RBT exam study guide: the six areas, task by task

The RBT exam covers six content areas and 43 tasks. This guide walks through each task with the key ideas to know, in plain language. Read an area, then practice it.

The exam has 85 multiple-choice questions (75 scored) and a 90-minute time limit.

Open RBT practice Try free sample questions

The six areas

  1. A · Data Collection and Graphing 8 tasks · 13 scored questions
  2. B · Behavior Assessment 3 tasks · 8 scored questions
  3. C · Behavior Acquisition 11 tasks · 19 scored questions
  4. D · Behavior Reduction 7 tasks · 14 scored questions
  5. E · Documentation and Reporting 4 tasks · 10 scored questions
  6. F · Ethics 10 tasks · 11 scored questions

8 tasks · 13 scored questions

A · Data Collection and Graphing

A.1 · Recording every occurrence: continuous measures

  • Count (frequency) records each instance of the behavior; rate expresses that count per unit of observation time.
  • Duration is the time from the start to the end of one occurrence; total and per-episode duration answer "how long".
  • Latency runs from the end of a cue or instruction to the start of the response; interresponse time runs from the end of one response to the start of the next.
  • The measure is chosen to match the concern the supervisor names: how often, how long, or how quickly the behavior happens.
Explanation, examples and a practice question: A.1 Recording every occurrence: continuous measures

A.2 · Sampling behavior in intervals: discontinuous measures

  • Partial-interval recording scores an interval if the behavior happens at any point in it; it tends to overestimate how much behavior occurred.
  • Whole-interval recording scores an interval only if the behavior lasts the entire interval; it tends to underestimate.
  • Momentary time sampling scores only whether the behavior is happening at the instant the interval ends.
  • Discontinuous methods yield a percentage of intervals, an estimate, not a count of every occurrence.
Explanation, examples and a practice question: A.2 Sampling behavior in intervals: discontinuous measures

A.3 · Measuring the lasting results of behavior

  • Permanent product recording measures a tangible outcome the behavior leaves behind, after the behavior has occurred.
  • It suits behaviors that reliably leave a product; behaviors that leave nothing must be observed as they happen.
  • The product must be attributable to the client: if someone else could have produced it, the record is not valid.
Explanation, examples and a practice question: A.3 Measuring the lasting results of behavior

A.4 · Entering data and keeping graphs current

  • Data are entered promptly from the raw record, exactly as collected, never reconstructed from memory or estimated.
  • On a line graph the horizontal axis shows sessions or time and the vertical axis shows the measure; each session is one data point.
  • A phase change line marks a change in conditions; points are not connected across it, and a session that did not happen is not plotted as zero.
Explanation, examples and a practice question: A.4 Entering data and keeping graphs current

A.6 · Calculating and summarizing data

  • Rate is the count divided by observation time, which allows comparison of sessions of different lengths.
  • Percentage divides the number of correct responses (or scored intervals) by the total opportunities (or intervals) and multiplies by 100.
  • Mean duration per occurrence is the total duration divided by the number of occurrences.
  • The summary is chosen to fit the data: rate when observation time varies, percentage when the number of opportunities varies.
Explanation, examples and a practice question: A.6 Calculating and summarizing data

A.7 · Reading trends in graphed data

  • Trend is the overall direction of the data over time: increasing, decreasing, or flat.
  • Trend differs from level (where the data sit on the vertical axis) and from variability (how much they bounce).
  • Whether a trend is good depends on the goal for that behavior; a trend is read from several points, not one.
Explanation, examples and a practice question: A.7 Reading trends in graphed data

A.8 · Risks of unreliable data and poor implementation

  • Inaccurate data can lead the supervisor to wrong decisions, such as declaring mastery too early or changing a plan that works.
  • When a plan is not implemented as written, results cannot show whether the plan itself works.
  • Recording errors, drifting definitions and implementation slips are reported to the supervisor, not corrected silently or filled in.
Explanation, examples and a practice question: A.8 Risks of unreliable data and poor implementation

3 tasks · 8 scored questions

B · Behavior Assessment

B.1 · Running preference assessments

  • Paired-stimulus assessment offers two items at a time until every item has been paired with every other.
  • In a multiple-stimulus array the chosen item is either removed for the next trial (without replacement) or put back (with replacement).
  • A free-operant assessment gives open access to items and records time spent with each, without removing anything.
  • Preferences shift, so brief assessments are repeated often, as the supervisor directs.
Explanation, examples and a practice question: B.1 Running preference assessments

B.2 · Helping assess skill strengths and needs

  • Assessment items are given exactly as the protocol states, without extra prompts, hints or reinforcement.
  • The technician records the response that actually occurred, not a skill assumed from another source.
  • The supervisor selects assessments and interprets results; the technician collects data and reports observations.
Explanation, examples and a practice question: B.2 Helping assess skill strengths and needs

B.3 · Helping with functional assessment

  • Descriptive (ABC) recording notes what happened right before and right after the behavior, in order, without guessing the reason.
  • Descriptive assessment observes events as they naturally occur; a functional analysis deliberately arranges test conditions.
  • In functional analysis conditions the technician delivers exactly the programmed consequences and follows the stop and safety rules.
Explanation, examples and a practice question: B.3 Helping with functional assessment

11 tasks · 19 scored questions

C · Behavior Acquisition

C.1 · Delivering reinforcement

  • Positive reinforcement adds a stimulus and negative reinforcement removes one; both make the behavior more likely in the future.
  • Reinforcement works best when delivered immediately and only after the target response.
  • Schedules: continuous reinforcement for new skills; fixed or variable ratio (responses) and interval (time) schedules for thinning.
  • Magnitude, intensity and variety are adjusted to the effort of the task and to signs of satiation.
Explanation, examples and a practice question: C.1 Delivering reinforcement

C.4 · Teaching in natural routines

  • Naturalistic teaching follows the learner's interests and arranges the setting so the learner initiates.
  • The consequence is naturally related to the response, such as getting the item the learner asked for.
  • It differs from discrete-trial teaching in who initiates, where it happens and what the reinforcer is.
Explanation, examples and a practice question: C.4 Teaching in natural routines

C.6 · Running discrimination training

  • A discriminative stimulus signals that a response will be reinforced; an S-delta signals that it will not.
  • Reinforcement follows responses made when the SD is present and is withheld for responses made when the S-delta is present.
  • Positions and materials are varied so the learner responds to the relevant feature, not to an irrelevant cue.
Explanation, examples and a practice question: C.6 Running discrimination training

C.7 · Using prompts and fading them

  • Response prompts act on the learner's response (verbal, gestural, model, physical); stimulus prompts change the materials (position, size, color).
  • Least-to-most moves to more help only after no response or an error; most-to-least starts with full help to keep errors low.
  • Time delay waits a set number of seconds after the instruction before prompting, increasing the wait over sessions in the progressive form.
  • Prompts are faded as planned so responding comes under control of the natural cue, avoiding prompt dependence.
Explanation, examples and a practice question: C.7 Using prompts and fading them

C.8 · Promoting generalization

  • Stimulus generalization is the skill occurring with new people, settings or materials that were not part of teaching.
  • Teaching with several examples, people and settings makes generalization more likely; it is planned, not assumed.
  • Response generalization is a new but functionally similar response appearing without being taught.
Explanation, examples and a practice question: C.8 Promoting generalization

C.10 · Shaping new behavior

  • Shaping reinforces successive approximations of a target behavior that the learner does not yet perform.
  • Once a closer approximation is reliable, earlier approximations are no longer reinforced, and criteria rise in small steps.
  • Shaping changes one response gradually; chaining links different steps; prompting adds help to an existing response.
Explanation, examples and a practice question: C.10 Shaping new behavior

C.11 · Running token economies

  • Tokens are delivered immediately after the target behavior, usually with praise, and later exchanged for backup reinforcers.
  • Exchanges follow the planned schedule and price list, set by the supervisor.
  • Backup reinforcers keep their value only if they are not freely available outside the system.
Explanation, examples and a practice question: C.11 Running token economies

7 tasks · 14 scored questions

D · Behavior Reduction

D.1 · Recognizing common functions of behavior

  • Common functions are access to attention, access to items or activities, escape from demands or situations, and automatic (sensory) reinforcement.
  • Function is identified from what reliably follows the behavior, not from what the behavior looks like.
  • Function describes a relation with the environment, not a motive or a character judgment.
Explanation, examples and a practice question: D.1 Recognizing common functions of behavior

D.2 · Applying antecedent strategies

  • Noncontingent reinforcement delivers the maintaining reinforcer on a time schedule, regardless of behavior.
  • A high-probability request sequence presents several easy requests the learner usually follows, then the harder request.
  • Demand fading starts with few or easy demands and increases them gradually as problem behavior stays low.
Explanation, examples and a practice question: D.2 Applying antecedent strategies

D.3 · Applying differential reinforcement

  • DRO reinforces the absence of the problem behavior for an interval; DRA reinforces a specific alternative behavior.
  • DRI reinforces a behavior that is physically incompatible with the problem behavior; DRL reinforces lower rates rather than zero.
  • Functional communication training teaches a communication response that produces the same reinforcer as the problem behavior.
Explanation, examples and a practice question: D.3 Applying differential reinforcement

D.4 · Applying extinction

  • Extinction withholds the specific reinforcer that has maintained the behavior.
  • What extinction looks like depends on function: for escape, the demand stays in place; for attention, attention is withheld.
  • Extinction must be applied consistently by everyone and through any temporary increase, within the safety limits of the plan.
Explanation, examples and a practice question: D.4 Applying extinction

D.5 · Applying punishment procedures

  • Positive punishment adds a stimulus and negative punishment removes one; both make the behavior less likely in the future.
  • Time-out removes access to reinforcement for a set time and only works if the setting left behind is reinforcing.
  • Punishment is defined by its effect on future behavior, and only procedures in the written plan are used.
Explanation, examples and a practice question: D.5 Applying punishment procedures

D.6 · Side effects of extinction and punishment

  • Extinction may bring an extinction burst, new forms of the behavior, emotional responses, and later spontaneous recovery.
  • Resurgence is the return of a previously reinforced behavior when a newer behavior stops being reinforced.
  • Punishment may bring emotional responses and escape or avoidance of the person or setting linked to it.
Explanation, examples and a practice question: D.6 Side effects of extinction and punishment

4 tasks · 10 scored questions

E · Documentation and Reporting

10 tasks · 11 scored questions

F · Ethics

F.8 · Following the rules on gifts

  • The technician does not give or accept gifts worth more than US$10 (or the equivalent purchasing power elsewhere) with clients, stakeholders or supervisors, and also weighs the context, repeated gifts and any stricter employer rule (RBT Ethics Code 1.11).
  • A gift can be declined kindly, with an explanation of the rule, and the supervisor informed.
Explanation, examples and a practice question: F.8 Following the rules on gifts

Test what you just read

Open RBT mode to practice one area at a time or take the timed mock: 85 questions in 90 minutes, corrected at the end with an explanation for every answer.

Open RBT practice

Independent study resource. Interlaza is not affiliated with or endorsed by the BACB. This guide is written in our own words from the outline, is not the required 40-hour training or the competency assessment, and does not predict or guarantee a pass.