BCBA® task C.5 · Area C

C.5 Continuous versus discontinuous measurement

3 min read · BCBA® Test Content Outline, 6th edition

What it means

Continuous measurement detects every occurrence within the observation period. Event recording and timing duration, latency or IRT are continuous. The word refers to that period: a 20-minute session recorded this way is continuous even though the rest of the day goes unobserved. Discontinuous measurement samples the period, so some occurrences, or parts of them, are missed. Interval recording and time sampling are discontinuous, and their result is the percentage of intervals or moments in which behavior was scored. That percentage estimates the behavior; it is not a count and not a rate. Sampling lowers the demand on the observer and lets one person track several behaviors or several people at once, at a cost in accuracy, so the choice weighs what the data must show against the observer’s time and duties.

Everyday example

One aide needs data on hand-flapping for three children during the same 15-minute circle time. Counting every flap for all three is impossible. Checking each child in turn at the end of every 30-second interval is manageable and gives an estimate for each child, reported as the percentage of checks with flapping.

Common confusion

Interval data cannot be turned back into a count or a rate: one scored interval may hold one response or ten. Observing every day does not make a sampling procedure continuous, and a short observation period does not make event recording discontinuous.

Key points

  • Continuous measurement (event, duration, latency, IRT recording) detects every occurrence within the observation period; continuity refers to that period, not to the whole day.
  • Discontinuous measurement samples the period, so some occurrences go undetected; its result is a percentage of intervals that estimates the behavior, never a count or a rate.
  • Discontinuous procedures lower observer demands and allow several people or behaviors to be measured at once, at the cost of accuracy; the choice weighs what the data must show against the observer's resources.

Examples from practice

Example 1

A swim coach times every lap a swimmer completes during a 30-minute practice: continuous (duration).

Example 2

During a 10-minute morning check-in, an office manager notes how many seconds pass between each request and the moment a new employee starts on it: continuous (latency).

Non-example

Looking up every 5 minutes, all day long, to see whether a resident is pacing is not continuous. Observing for many hours does not stop it from being a sample.

Check yourself

One question from the course lesson on this task. Choose an answer to see why it is right or wrong.

Which procedure is continuous measurement?

Show the answer and the explanations

Answer: B. Timing every tantrum during a 20-minute visit

  • a. Looking only at one moment per minute is momentary time sampling, which is discontinuous.
  • b. Correct. Every tantrum in the visit is timed, so nothing in the observation period is missed. The short visit does not change that.
  • c. This is partial-interval recording. A full shift of observation is still a sample of intervals, not a record of each occurrence.

The full lesson is in the course

The course lesson on this task goes further, with more sections, more examples and more practice questions, and keeps a record of what you have mastered.

Open the lesson Practice this task

Try a sample free, without an account

Key terms

Each term opens its definition in the ABA glossary.

All tasks in area C All 104 tasks ABA glossary: every term in one page

Independent study resource. INTERLAZA is not affiliated with or endorsed by the BACB. The explanations and examples are original, are not official exam content and do not reproduce any exam item.